A&D TM-2430-13 Instruction Manual download pdf (Page 13)

Page 11

Automatic measurement

The measurement starts or stops using the AUTO ON/OFF key. When the

measurement is started, the recorder begins to work in accordance with preset

time intervals from the preset time of the internal clock. Refer to "Selection for the

Automatic Measurement".

In the automatic measurement, "A" appears in the upper left of the display.

The recorder automatically measures the patient's blood pressure at the time that is

pointed out by "the frequency" and "the start time" (by the programmed time intervals).

When a measurement error occurs and there is 8 minutes until the next

measurement, the measurement is retried after approx. 30 seconds.

If a measurement is retried, only the data from the retry is saved.

The recorder automatically adjusts the proper pressure, exhaust velocity and end

of measurement.

Refer to "Selection for the Automatic Measurement" and "Automatic Measurement

(by Programmed Time Intervals)" about operation and entering parameters.

Stopping a measurement

If you press the START STOP key during a measurement, the recorder exhausts the

air and stops the measurement.

Concealing the measurement value

This function works only while using automatic measurement.

This function does not display the SYS, DIA or pulse rate for the automatic

measurement, but the data is saved in memory.

This function can select "reveal" or "conceal" at "Parameters for the Display and

Clock". Refer to this section.

If you select "conceal", the recorder displays the clock during a measurement.

If you reset the recorder, this parameter is set to "reveal".

Pressurization

The pressure is automatically selected by the recorder while in the automatic

measurement mode.

The first pressure is set to approx. 185 mmHg. This value automatically varies to

the proper value after first measurement. If the first inflation is not successful, the

recorder retries twice.

If you reset the recorder, the first inflation value is set to 185 mmHg.

Memory

The recorder can store 350 sets of data (the memory capacity is 350).

A data set consists of the SYS, DIA and pulse rate.

When memory becomes full, the recorder displays an "M". Until you delete the

data, you cannot measure blood pressure.

When the recorder saves data for more than one patient, data management

becomes complicated. We encourage that each patient's data is recorded, transferred

and is deleted from memory.

When "B" is displayed, the backup battery that stores a patient’s data is weak.

Please transfer the data and save it in other media as soon as possible.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 46 47

Comments to this Manuals

No comments

A&D TM-2430-13 Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Blood pressure units A&D TM-2430-13