A&D AD-4408A Instruction Manual download pdf (Page 17)

6. Errors

6.1. Error Types

Error Status Flag

This conveys to the master device that an error has occurred.

Turn the error reset flag ON to request resetting the error status flag.

Table 9 Error status flag

Error type Causes

Checksum error Program checksum does not match.

Input (A/D) error Data can not be acquired from the A/D converter.

FRAM error Data can not be written into the FRAM.

Calibration error Calibration data is not correct.

Mode error Moved to a mode other than the weighing mode.

Weighing Failure

This conveys a weighing failure to the master device.

This will be reset when normal weighing has resumed.

Table 10 Weighing failure

Error type Causes

Zero error Zero adjustment is not performed.

Tare error Tare is not performed.

Net display error A net value is not displayed.

Capacity exceeded The weighing capacity has been exceeded.

Capacity Exceeded

This conveys to the master device that the weighing capacity has been exceeded.

This will be reset when all the errors are cleared.

Table 11 Capacity exceeded

Error type Causes

Net over The net weight is over the net weight range.

Net under The net weight is below the net weight range.

Gross over The gross weight is over the gross weight range.

Gross under The gross weight is below the gross weight range.

A/D over A/D value is over the A/D value range.

A/D under A/D value is below the A/D value range.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

No comments

A&D AD-4408A Instruction Manual Page 17