3
2. Description of Each Part
Fig.1 Interface module part names
NOTE: 1. A TORX
®
driver (size T9) to fasten the retaining screws is not provided
with the interface module.
2. A connector for the cable side (D-Sub 9-pin male) is not provided with
the interface module.
2.1. Status LEDs
NOTE: The illustration below shows how the interface module is positioned when
installed to the AD-4408A.
Fig.2 Position of status LEDs
Table 1 Device status LED (DS)
LED state Description
OFF Initializing / No power
Green ON Normal
Red ON Hardware malfunction
Red, single flash Communication error / Setting error
Red, double flash Recoverable error
Communication LED
69
51
Device status LED
Locking
catch
Ground
NOTE 2
Communication
connecto
NOTE 1
Retaining
screw
Device status LED
Communication LED
Locking
catch
Comments to this Manuals