A&D AD-4408A Instruction Manual download pdf (Page 7)

3. Installation

3.1. Interface Module Installation

Install the interface module as follows:

Step 1 Using a Phillips screwdriver,

loosen the screws that secure

the blank panel to the

AD-4408A rear panel, and

remove the blank panel.

Step 2 Insert the interface module

into the option slot as shown

to the right.

Step 3 Insert the interface module

until it mates with the terminals

of the PC board connector

located in the option slot.

Step 4 Using a TORX

driver (size

T9), fasten the retaining

screws with a tightening

torque of 0.25 Nm in the

clockwise direction to secure

the interface module.

Fig.4 Interface module installation

NOTE: A TORX

driver is not provided with the interface module.

Be sure to disconnect the AD-4408A from the power source before

installing the interface module.

Step 1

Step 2

Step 3

Step 4

Blank panel

Interface module

Option slot

Retaining screw

PC board

in the option slot

Tightening torque

0.25 Nm

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

No comments

A&D AD-4408A Instruction Manual Page 7